A great handheld LCR analyser that can measure the value of your passive component (inductor, capacitor or resistor) and also measure the detailed impedance in a number of modes. The LCR45 offers enhanced measurement resolution (better than 0.1uH!) whilst also giving you continuous fluid measurements. Additionally, the test frequencies of DC, 1kHz, 15kHz and 200kHz can be set to automatic or manual modes. Supplied with removable gold plated hook probes, battery and user guide. Compatible with standard 2mm test connectors. Not designed for in-circuit use.

Key Features

Automatic or manual component type selection: Inductor, Capacitor or Resistor.
Automatic or manual test frequency selection: DC, 1kHz, 15kHz and 200kHz.
Inductance from 0.1uH to 10H.
Capacitance from 0.1pF to 10,000uF.
Resistance from 0.1Ohm to 2MOhm.
Inductance measurement also shows DC winding resistance.
Display of "Component type and values", "Complex Impedance", "Magnitude/Phase" and "Admittance".
Test frequency displayed for all measurements.
Typical accuracy of 1.5% for inductors and capacitors (see spec table for details).
Typical accuracy of 1% for resistors.
Test lead complete with gold plated 2mm plugs and sockets.
Supplied with removable gold plated hook probes.

Parameter		Min	Typ	Max	Note
Resistance	range	0Ω		2MΩ
	resolution	0.1 Ω	0.2Ω
	accuracy	Typically ±1.0% ±0.6 Ω			1,2,6
Capacitance	range	0pF		10,000µF
	resolution	0.1pF	0.2pF
	accuracy	Typically ±1.5% ±0.6pF			1,2,5
Inductance	range	0µH		10H
	resolution	0.1µH	0.2µH
	accuracy	Typically ±1.5% ±0.6µH			1,2,4
Passive Component Impedance	Re & Im	Typically ±1.5% ±10 LSD			4,5,6
	Magnitude	Typically ±1.5% ±10 LSD			4,5,6
	Phase	Typically ±5°			4,5,6
Measurement Sample Rate		0.5Hz	1.5Hz	2Hz
Peak test voltage (across O/C)		-1.05V		+1.05V
Peak test current (thru S/C)		-3.25mA		+3.25mA
Test frequency accuracy	1kHz	Typically ±0.5%
	14.9254kHz				7
	200kHz
Sine purity		Typically -60dB 3^rd harmonic
Operating temperature range		10°C		40°C	3
Battery operating voltage		8.5V		13V

Notes for table above:
1. Within 12 months of factory calibration. Please contact us if you require a full re-calibration and/or certification of traceable calibration.
2. Specified at temperatures between 15°C and 30°C.
3. Subject to acceptable LCD visibility.
4. For inductances between 100µH and 100mH in fully auto mode.
5. For capacitances between 200pF and 500nF in fully auto mode.
6. For resistances between 10Ω and 1MΩ in fully auto mode.
7. For clarity, the 14.9254kHz test frequency is shown as 15kHz.